1160 S POSITANO AVEPermit Types CITY OF ANAHEIMPLMBLDELEMEC
X BUILDING DIVISION
200 S.ANAHEIM BLVD.
(714)765-5153
Permit Number:BLD2023-06676
Issued:12/15/2023
www.anaheim.net/building
(714)765-4626
Quarter Section:221
Site Address:1160 S POSITANO AVE,ANAHEiM,CA 92808
Legal Description:N TR 12697 BLK LOT 7 UN 144 TRACT 12697,LOT 7 OF
APN:93044554
Project Description:Eiectricai for EV Charger Level 2
0.000Valuation:Number of Stories:Living Area:
Garage Area:
Carport Area:
Balcony I Deck Area:
Cool Roof:
N/AConstructionTypes:
Occupancy Groups:
Fire Spnnklered:
Total Fees paid for Permit:172.00
People Associated with Project:
3731 W WARNER AVE 014 SANTA ANA,CAContractor
Permit Applicant
Owner
PREMIER POWER INC
Andrew Yassa
KAVEH,HAYDEHTRTHE 1160 S POSITANO AVE
QtyMechanicalFixturesQtyQtyTypePlumbingFixturesTypeElectricalFixtures
1EVCharger
The permit shall expire by limitation and become null and void if the building or work has not passed final inspection 365 days from the
date of permit issuance.A new permit is required to commence or continue work.
INSPECTORDATEFINALINSPECTIONS
City of Anaheim
Building Division
AM applicable items below must be signed before utilities are released
Final Gas Test
WhsElectricalFinal
Plumbing Final
Mechanical Final
Cross Connection Control (714)765-4280
Do not occupy this building until the final inspections have been made.Engineering Final (714)765-5126
DATE INSPECTOR Fire Sprinkler (ONLY)(714)765-5041INSPECTION
Do not pour concrete until the following applicable items have been signed:Fire Dept.Final (714)765-5041
Water Engineering (714)765-4591Plumbing(Ground/Underfloor Drain Waste)
Sub List/Bus.Lie.(714)765-5194 (Allow 10 business days)Electrical Ground Electrode/Ufer
COA/Migation MeasuresSetback/Forms/Trenches (Footings)
Do not install subfloor or pour floor slab until the follwing applicable items have been
Building Final (714 765-5153)
Last Inspection-Final Only After Above CompletedPlumbing(Ground/Underfloor Water)
Underfloor Rough Gas
PARTIAL INSPECTIONSMechanical(Groundwork)
Building InspectionsElectrical(Underground Conduit)
Pre-slab (Compaction/Membrane Reinf.)
Floor (Joist/Girders)
Underfloor Insulation (Raised Foundation Only)
Floor Nailing (Raised Foundation Only)
2nd Floor (Floor Nailing)
Do not cover or conceal the work below until the following applicable items have
been signed.
1st Floor Shear
Mechanical InspectionsFiresprinkler(Rough)(Fire Dept.)
2nd Floor Shear
Roof (Sheathing/Diaphragm/Frame)
Masonry (Reinf./Bond Beam/Pre-Grout)
Rough Plumbing (Top Out)
Rough Duct (Mechanical)
Rough Mechanical
Rough Electrical
Plumbing InspectionsRoughCOA/Mitagation Measures
Framing (Only after PIbg.,Ele..Mec.&Fire)
Insulation (Sound/Energy)
Do not tape or plaster until the following applicable items have been signed:
Drywall
Drywall Penetrations (Ele,Mec &PIbg)
Interior Lath
Electrical InspectionsExteriorLath
Electrical Service Meter-(Meter will be set within 2-3
business days after approval)Excludes New
Construction
Exterior Plaster (Brown Coat)
T-Bar (Struct.,Ele.,or Mec.)
Grease Interceptor
'■Du.not backtill imiess stuned otii
Sewer
Water Engineering Backflow (Testable Only)
Water Service
General Information T
The Mobile Connector is 20 feet (6 meters)long.Use an existing outlet or install a new outlet
within approximately 13 feet (4 meters)of the vehicle's charge port and at least 18 inches (45 cm)
above the ground.The charge port is located on the left side of the vehicle,behind a door that is
near the rear tail light assembly.
Warning:Do not use an extension cord,a multi-outlet adapter,a multi-plug,a conversion
plug,or a power strip to plug in the Mobile Connector.
Specifications Reference
Description Specifications
Voltage 100-240 volt AC single-phase
Maximum Current 32A maximum;controlled by the appropriate adapter
Grid Frequency 50 or 60 Hz
Cable Length 20 ft (6 m)with adapter installed
Mobile Connector Controller
Dimensions
Height;7.1 in (179.8 mm)
Width:3.2 in (81.7 mm)
Depth:1.9 in (47.3 mm)
5.2 lbs (2.4 kg)Weight
-22°F to +122°F (-30°C to +50°C)Operating Temperature
Enclosure Type 4X
Not RequiredVentilation
Charging Time
Charging times vary based on the voltage and current available from the power outlet,subject to
various conditions.Charge time also depends on ambient temperature and the vehicle’s Battery
temperature.If the Battery is not within the optimal temperature range for charging,the vehicle
heats or cools the Battery before or during charging.
To estimate the total time it takes to recharge the Battery in hours (from near zero percent to near
one hundred percent),divide the battery size (kWh)by power (kW).Different adapters provide
different current and power outputs.
While you are charging your vehicle,you can also touch the Charging icon to review the charging
status information:it displays the time remaining until fully charged at the currently selected
charge level.
For more information on how long it takes to charge your Tesla vehicle,go to www.tesla.com/
support.
Charging Rate Reference
Power at 120 VoltsAdapterCurrent
1.7 kW5-20 16A
5GeneralInformation
T General Information V
Power at 120 VoltsCurrentAdapter
1.3 kW12A5-15
Power at 240 VoltsCurrentAdapter
7.6 kW32A14-50,6-50
24A 5.7 kW14-30,10-30
16A 3.8 kW6-20
2.8 kW12A6-15
6